Programming 15088:J 10/22/99
3-7
Section One
Main Programming
The Programming Mode is accessed by entering the following (level 2 password required):
D} X
After entering the Programming Mode, the display will show the Main Programming menu:
PRESS@1=PSYS,2=FSYS,3=PPRG,4=FPRG,5=REMV,6=PSWD,7=MSG,8=HIS@@@@@@@@@@@@@@@@@@:
The Main Programming menu has eight options, where:
1=PSYS Partial System Programming - Selective programming of system-wide functions
(number of LIBs, AVPS-24/AVPS-24E*, ISIB, Signal-Silence Inhibit and Cut-out, Alarm
Verification, number of annunciator modules, etc.).
2=FSYS Full System Programming - Complete programming of system-wide functions (num-
ber of LIBs, AVPS-24/AVPS-24E*, ISIB, Signal-Silence Inhibit and Cutout, Alarm Verifi-
cation, number of annunciator modules, etc.).
3=PPRG Partial Point Programming - Selectively altering the operating parameters of LIB
SLC Loop devices, software-defined zones and annunciator points.
4=FPRG Full Point Programming - Complete programming of addressable LIB SLC Loop de-
vices, software-defined zones, annunciator points and their respective operating pa-
rameters.
5=REMV Remove - Permits the selective removal (from control panel memory) of any of the
system's addressable SLC Loop devices, software-defined zones or annunciator
points.
6=PSWD Password - Allows the programmer to assign custom five-digit Level One and Level
Two passwords.
7=MSG Message - Allows the Level Two programmer to define the custom 40-Character User
Label displayed on the CRT Monitor and the panel's Liquid Crystal Display (LCD).
8=HIS History - Allows the programmer to enable or disable storage of events and the clear-
ing of stored events.
* The number of APS-6R power supplies should be included in the AVPS count.
The Main Programming Menu flow chart is located in Figure 1-1. Detailed information on the Main Programming
options follows.
www.PDF-Zoo.com
To Next Page
Loading...
Need help?
General
