Notifier AFP1010 User Manual

3-22
Programming 15088:J 10/22/99
Section 1.1.8 Intelligent Serial Interface Board Programming
D }X1X8X
8=ISIB
Option 8 from the Partial System Programming Menu allows the programmer to change parameters associated with an
Intelligent Serial Interface Board (ISIB). ISIB Programming has four submenu options, ISIB Installation, Annunciator
Installation, External Interface Parameters and UDACT Selection. Detailed descriptions of the four ISIB programming
options are located on the pages that follow. The SIB-2048A and SIB-NET ISIBs are available for use with the AM2020/
AFP1010. For AM2020/AFP1010 with NOTIFIRENET the SIB-NET is the only ISIB available. Refer to
Chapter One, Serial Communications , for a description of available intelligent serial interface boards.
Figure 1-8 Intelligent Serial Interface Board Option Flow Chart
8 = ISIB
Select ISIB
Submenu Option 1-4
1 = INSTL
(Sib installation)
Change
ISIB?
Enable/Disable
ISIB
Yes
No
2 = ANN
(annunciator
installation)
Enter annunciator
to be changed
(1-32)
No
Yes
Yes
No
No
Install
annunciator
selected?
Enter
Label
Change
Another?
Change
SIB
Address?
Change
Upload/
Download?
3 = XINT
(external
interface)
Yes
No
Enable/Disable
Upload/Download?
Enter SIB Address
Change
Channel
A Threshold?
Change
Channel
B Threshold?
Change MIB
Data Port
Monitoring?
No
Yes
Enter Channel
A Threshold
Enter Channel
B Threshold
Enter Number of
Channels to
Monitor
Do you want
ACK/SIL/RES
disabled at panel?
Change
ACK/SIL/RES?
No
No
No
No
No
Do you want
ACK/SIL/RES re-
enabled on LAN
Comm Fault?
No
No
4 = DACT
(communicator
transmitter)
Change
UDACT
programming?
Install UDACT?
Enter base
address (1-32)
Yes
Yes
Yes
Yes
Yes
Yes
(Exit Program
Mode)
ISIBFLOW.CDR
www.PDF-Zoo.com

Notifier AFP1010 Specifications

General

Brand	Notifier
Model	AFP1010
Category	Fire Alarms
Language	English