139 Using the Scanner
Deleting a Specified Destination Address
A specified destination address (e-mail address, FTP address or SMB address)
can be deleted.
" Changes made with this procedure will not be applied to the original data
(speed dial destination, group dial destination, etc.).
1 In the main screen (Scan mode), press the up or down arrow key to select the
current data destination setting, and then press the Enter key.
2 To delete an e-mail address, press the up or down arrow keyy to select
CHECK/EDIT, and then press the Enter key. Then, press the up arrow or
down arrow key to select the address to be deleted. To delete an FTP
address or SMB address, continue with step 3.
3 Press the Stop/Reset key.
4 Press the up or down arrow key to select YES, and then press the Enter key.
The selected address is deleted.
" If all specified addresses are deleted, the main screen is displayed.
5 To delete another address, repeat the procedure from step 2.
6 To finish deleting addresses, press the Back key.
7 Press the up or down arrow key to select FINISH, and then press the Enter
key.
Registering/Editing Addresses
Addresses can be registered/edited in the favorite list, as speed dial destinations
or as group dial destinations.
" The same settings menu used to register/edit fax numbers is used to reg-
ister/edit addresses. For details on registering/editing fax numbers, refer
to the Facsimile User’s Guide on the CD.
To Next Page
Loading...
Need help?
General
