Omron NX-EIC202 User Manual

6 - 11
6 Installation
NX-series EtherNet/IP Coupler Unit User’s Manual (W536)
6-1 Installing Units
6
6-1-4 Installing the EtherNet/IP Coupler Unit
3 Press the EtherNet/IP Coupler Unit firmly against the DIN Track until you hear the DIN Track
mounting hook lock into place.
After you mount the EtherNet/IP Coupler Unit, check to be sure that it is securely mounted on
the DIN Track.
Precautions for Correct Use
The EtherNet/IP Coupler Unit may not be mounted properly to the DIN Track if the protrusions
on the left back of the EtherNet/IP Coupler Unit interfere with the screw that fixes the DIN Track
as shown in the following figure.
When you mount the EtherNet/IP Coupler Unit to the DIN Track, avoid interference of the pro-
trusions on the left back of the EtherNet/IP Coupler Unit with the screw on the DIN Track. (This
applies to Ethernet/IP Coupler Units with lot numbers through December 2014.)
Additional Information
It is not normally necessary to unlock the DIN Track mounting hooks when you mount the Eth-
erNet/IP Coupler Unit. However, if you mount the EtherNet/IP Coupler Unit on a DIN Track that
is not one of the recommended DIN Tracks, the DIN Track mounting hooks may not lock prop-
erly. If that happens, unlock the DIN Track mounting hooks at the start of the procedure, mount
the Unit to the DIN Track, and then lock the DIN Track mounting hooks.
DIN Track
mounting
hooks
EtherNet/IP
Coupler Unit
Press firmly.
DIN Track

Omron NX-EIC202 Specifications

General

Brand	Omron
Model	NX-EIC202
Category	Controller
Language	English