EasyManuals Logo
Home>Onkyo>Car Receiver>CR-N7

Onkyo CR-N7 User Manual

Onkyo CR-N7
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
38
Listening to an FM/AM Station—Continued
1 Turn on the power to the CD receiver.
2 Select FM or AM.
3 Press or repeatedly while observing
the display to tune in the desired frequency.
Each press of the button changes the frequency by
0.05 MHz for FM and 9 kHz for AM. Pressing and
holding down the button for more than one second
will change the frequency continuously.
While FM is selected, pressing and holding or
down a while, then releasing it, will automati-
cally raise (or lower) the frequency.
When using the remote controller, press INPUT /
to select FM or AM, and press / to tune
in the desired frequency.
If FM reception is not good
If reception is poor or much noise is heard, press YES/
MODE to turn off the AUTO indicator and switch to
monaural reception. In this way, you can reduce noise or
dropped signals. To return to AUTO tuning, press YES/
MODE again.
Using the Remote Controller
Selects an FM/AM station.
Selects a preset channel.
(Pressing selects a lower
channel number and pressing
selects a higher channel
number.)
Preset
channel
Press the number buttons as
described in the examples
below to select the desired
preset channel.
Press
8
10
22
represents the tens digit.
Enables you to manually
tune in a broadcast station.
(See the following section.)
Adjust the volume level.
(Pressing VOLUME increases
the volume level, and pressing
VOLUME decreases the
level.)
Manually Tuning a Broadcast Station
1
2
YES/MODE
AUTO
SOURCE
FM ST
SOURCE
Remote
controller
CD receiver

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo CR-N7 and is the answer not in the manual?

Onkyo CR-N7 Specifications

Power IconPower
power supplyAC 230–240 V, 50 Hz
power consumption68 W
stand-by power consumption0.3 W
Audio Inputs and Outputs IconAudio Inputs and Outputs
analog inputsLINE, TAPE, HDD
digital outputsOptical: 1
analog outputsTAPE, HDD
Amplifier Specifications IconAmplifier Specifications
power output14 W + 14 W (8 Ω, 40 Hz–20 kHz THD, 0.4%)
dynamic power26 W + 26 W (4 Ω, JEITA)
damping factor25 (8 Ω)
Tuner Specifications IconTuner Specifications
fm tuning frequency range87.5 MHz–108 MHz
am tuning frequency range522 kHz–1611 kHz
stereo separation40 dB (1 kHz)
CD Specifications IconCD Specifications
frequency response10 Hz–20 kHz
audio dynamic range92 dB
thd (total harmonic distortion)0.009 %
Weight and Dimensions IconWeight and Dimensions
dimensions205 W x 147 H x 356 D mm
weight4.3 kg

Related product manuals