_*_ll _ • $ • _ _ _t_ m 1_
3 _, .4 5 _>_
1 .2@ + "Setup",-
1_ .2@ .3 _ .4 _'q
Q@i "Setup" _ _@
Advanced Operations
Remote ID
m Remote ID
_l, 2, or3
When several Onkyo components are used in the same
room, their remote ID codes may overlap. To differentiate
the AV receiver from other components, you can change
its remote ID from "1", to "2" or "3".
With this preference, you can protect your settings by
locking the setup menus.
N Setup
Locked
Unlocked
When "Locked" is selected, the setup menus will he
locked and you cannot change any setting.
• If you do change the AV receiver's remote [D, be sure to change
the remote controller to the same [D (see below'), otherwise, you
won't be able to control it with the remote controller.
Changing the remote controller's ID
While holding down RECEIVER, press and hold
down Q SETUP until the remote indicator lights
(about 3 seconds).
2 Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.
Remote Mode Setup
See "Looking up for Remote Control Codes"
(_ page 68).
En-63
©©
To Next Page
Loading...
Need help?
General
