1
You'll need to enter a code for each component that you
want to control.
2
3
Look up the appropriate remote control code in the
separate Remote Control Codes list.
The codes are organized by category (e.g., DVD
player, TV, etc.).
While holding down tile REMOTE MODE button to
which you want to assign a code, press and hold
down DISPLAY (about 3 seconds).
The remote indicator lights.
• Remote control codes cannot be entered for RECEIVER
and the multi zone button.
• Only TV remote control codes call be entered for "FV.
• Except for RECEIVER, TV, and the multi zone button,
remote control codes from any category can be assigned for
the REMOTE MODE buttons. However, these buttons also
work as input selector buttons (3 page 22), so choose a
REMOTE MODE button that corresponds with the input to
which you connect your component. For example, if you
connect your CD player to the CD input, choose TWCD
when entering its remote control code.
Within 30 seconds, use the number buttons to enter
the 5-digit remote control code.
The remote indicator flashes twice.
If the remote control code is not entered successfully,
the remote indicator will flash once slowly.
You can change the configuration of colored buttons, with
which REMOTE MODE buttons are preset.
1
2
While holding down the REMOTE MODE button
that you want to program, press and hold down A
(Red) until the remote indicator lights (about 3
seconds).
You can only change colored buttons for components
whose codes belong to categories of the Remote
Control Codes list (BD/DVD player, TV, cable set-top
box, etc).
Within 30 seconds, press the colored buttons in the
order that you want to reassign them.
The button presses are assigned to each button from
left to right. The remote indicator flashes twice,
indicating that the sequence has been successfully
assigned. If the sequence is not successfully assigned,
the remote indicator will flash once slowly.
• To reset the REMOTE MODE buttons to their default settings,
see "Resetting the REMOTE MODE Buttons" (3 page 70).
• [f any other button than the colored buttons is pressed, the
operation will be cancelled.
• This operation cannot be done while the AV receiver is in
Receiver mode or when ZONE 2 is active.
Controlling Other Components
• Though the provided remote control codes are correct at the time
of release, they are subject to change.
En-69
©©
To Next Page
Loading...
Need help?
General
