Onkyo components that are connected via fat I are
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1 Make sure the Onkyo component is connected with
an R I cable and an analog audio cable (RCA).
See "Connecting Onkyo RI Components" for details
(_ page 17).
2 Enter tile appropriate remote control code for a
REMOTE MODE button, by referring to the
previous section.
42157:
Onkyo cassette tape deck with f_ I
_81993:
Onkyo Dock with f_l
3 Press the REMOTE MODE button, point the
remote controller at the AV receiver, and operate
the component.
Controlling Onkyo components without f_ I
If you want to control an Onkyo component by pointing the
remote controller directly at it, or you want to control an
Onkyo component that's not connected via f_ I, use the
following remote control codes:
30627:
Onkyo DVD player without R I
71817:
Onkyo CD player without R I
32900/33100/33500:
Onkyo Blu-ray Disc player
32901/33104/33504:
Onkyo HD DVD player
70868:
Onkyo MD recorder without R I
71323:
Onkyo CD recorder without F/I
82990:
Onkyo Dock without F/I
You can reset a REMOTE MODE button to its default
remote control code.
1
2
While holding down the REMOTE MODE button
that you want to reset, press and hold down HOME
until the remote indicator lights (about 3 seconds).
Within 30 seconds, press the REMOTE MODE
button again.
The remote indicator flashes twice, indicating that the
button has been reset.
Each REMOTE MODE button is preprogrammed
with a remote control code. When a button is reset, its
preprogrammed code is restored.
You can reset the remote controller to its default settings.
1 While holding down RECEIVER, press and hold
down HOME until the remote indicator lights
(about 3 seconds).
2 Within 30 seconds, press RECEIVER again.
The remote indicator flashes twice, indicating that the
remote controller has been reset.
En-70 V
Controlling Other Components
H
By pressing the REMOTE MODE button that's been
programmed with the remote control code for your
component, you can control your component as described
below.
For details on entering a remote control code for other
components, see "Entering Remote Control Codes"
(_ page 69).
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the rqll-llDq (limited to
some models). The TV must be able to receive remote
control commands via r'qll-llD and be connected to the
AV receiver via HDMI. If controlling your TV via
r'qll-llD doesn't work very well, program your TV's
remote control code into TV and use the TV remote mode
to control your TV.
Use the following remote control codes:
}11807/13100/13500:
TV with I--UIPIJE)
Controlling Apple TV
By programming the supplied remote controller with the
appropriate remote control code, you can use it to operate
your Apple TV.
Use the following remote control codes:
02615:
Apple TV
©©
To Next Page
Loading...
Need help?
General
