m Operating on the AV receiver
Input selector buttons
ZONE 2 OFF MASTER VOLUME
2
To turn on Zone 2 and select an input source, press
ZONE 2 followed by an input selector button within
8 seconds.
Zone 2 turns on, the Z2 indicator lights on the AV
receiver's display.
To select the same source as the main room's, press
ZONE 2 twice. "Z2 Sel: Source" appears on the AV
receiver' s display.
To turn off Zone 2, press OFF.
The zone is turned off.
m Operating on the remote controller
To control Zone 2, you must press ZONE2 on the remote
controller first.
ZONE2
SELECTOR
1 Press ZONE2, then point the remote controller at
the AV receiver and press _RECEIVER.
Zone 2 turns on, the Z2 indicator lights on the AV
receiver' s display.
2 To select an input source for Zone 2, press ZONE2,
followed by an INPUT SELECTOR button.
3 To turn off Zone 2, press ZONE2, followed by
_RECEIVER.
The zone is turned off.
Adjusting the Volume for Zone 2
m Operating on the remote controller
1 Press ZONE2.
2 UseVOL A/V.
M Operating on the AV receiver
1 Press ZONE 2 (the Z2 indicator on the AV
receiver's display flash).
2 Use MASTER VOLUME control within 8 seconds.
If your Zone 2 speakers are connected to a receiver or
integrated amplifier in Zone 2, use its volume control to
adjust the volume.
Advanced Operations
Muting Zone 2
mOperating on the remote controller
1 Press ZONE2 followed by MUTING.
• To unmute, press ZONE2 followed by MUTING again. Zone call
also be unmuted by adjusting the volume.
• Only analog input sources are output from the ZONE 2 LINE
OUT jacks and ZONE 2 L/R terminals. Digital input sources are
not output. If no sound is heard when an input source is selected,
verify that the source is connected to an analog input.
• You cannot select different AM or FM radio stations for your
main room and Zone 2. The same AM/FM radio station will be
heard in each room. Namely, if you have selected an FM station
for the main room, that station will also be output in Zone 2.
• When you have selected NET or USB as input selector, the last
selector selected will be set for Main room and Zone 2.
• When Zone 2 is activated and its input selector is selected, the
power consumption of standby mode slightly increases.
• While Zone 2 is on, 1"-41functions will not wrork.
• When setting the AV receiver to standby mode while Zone 2 is
active, the Z2 indicator is dimly lit.
• "EXTRAI" and "EXTRA2" cannot be selected as input sources
for Zone 2.
• When "EXTRAI" or "EXTRA2" is the input source of Main
room and Zone 2 is set to share the same source, no sound will be
output from Zone 2.
En-65 V
©©
To Next Page
Loading...
Need help?
General
