By pressing the REMOTE MODE button that's been
programmed with the remote control code for your Dock,
you can control your iPod/iPhone in the Dock with the
buttons described further in this section.
See "Entering Remote Control Codes" for details on
entering a remote control code (_ page 69).
See the Dock's instruction manual for more information.
RI Dock
• Set the RI Dock's RI MODE switch to "HDD" or
"HDD/DOCK".
• r3SOURCE may not work with a remote control code
(without [-41). In this case, make an 1-41connection and
enter the remote control code 81993 (with f-4I).
m With the RI Control
Make an f-41 connection and enter the remote control code
81993 (with 1-41).
• Set the AV receiver's Input Display to "DOCK"
(_ page 41).
@Without the RI Control
You must enter the remote control code 82990 first
(_ page 70).
®
Press the appropriate REMOTE t
MODE button first,
Controlling Other Components
m RI Dock operation
Q
T
T
®
__ RANDOM _ MODE'4
• With some iPod/iPhone models, generations and RE Docks,
certain buttons may not work as expected.
• For detailed operation of iPod/iPhone, please refer to the
instruction manual of the RE Dock.
"1 TOP MENU works as the mode button when used with the
DS-A2 RE Dock.
*2 This button does not turn the Onkyo DS-A2 or DS-A2X RE
Dock on or off. Also, your iPod/iPhone may not respond the
first time you press this button, in which case you should press
it again. This is because the remote controller transmits the On
and Standby commands alternately, so if your iPod/iPhone is
already on, it will remain on when the remote controller
transmits the On command. Similarly, if your iPod/iPhone is
already off, it will remain off when the remote controller
transmits the Off command.
*3 DISPLAY turns on the backlight for a few' seconds.
*4 Resume mode
With the Resume function, you can resume playback of the
song that was playing when you removed your iPod/iPhone
from the Onkyo DS-A2 RE Dock.
En-67
©©
To Next Page
Loading...
Need help?
General
