Setting the Time, Network Address, and Library Parameters
System Configuration 4-9
You can only remove assigned resources.
4. If you need to assign resources to another partition, repeat the preceding steps
until you have assigned the required resources to all partitions.
5. If at any point you do not wish to proceed, press the Previous button to go back
one screen or Cancel to quit.
6. To reassign the resources, press the Next button.
7. Next, review and apply the configuration changes.
Review and Apply Configuration Changes
1. When the Summary of Configuration Changes sheet appears, review the changes
that you have made and make sure that they make sense in the context of your
overall configuration.
Changed settings are flagged by the word changed in the Changes column of the
summary table.
2. Notice any alerts that appear above the button bar beneath the summary.
If the library has to go offline or restart to make the specified changes, you are
notified here.
3. If you see a problem, press the Previous button to return to an earlier screen or
Cancel to quit.
4. Otherwise, if everything seems correct, check the Accept all changes check box to
confirm, and press the Apply button.
The Apply button is grayed out until you check the confirmation check box.
After you press Apply, the library goes off-line, if needed, applies all changes,
restarts if necessary, and returns to its starting state (offline if it was offline when
reconfiguration commenced, online if it was online).
5. If you configured dual-stack, IPv6/IPv4 network connectivity, be sure to test web
browsers with IPv6.
Support for IPv6 can vary considerably between browsers and browser releases.
So you may or may not be able to connect to the library user interface via IPv6
when using a given browser.
6. Next, go to "Checking and Updating Library and Drive Firmware" on page 4-10.
Test Web Browsers with IPv6
Support for IPv6 can vary considerably between browsers and browser releases. Most
work well with IPv6-enabled Domain Name Service (DNS). But many browsers do not
currently support IPv6 addresses, and, when they do, proxy configurations may cause
problems. So perform some simple tests before using the browser-based SL150 user
interface with IPv6:
1. In the address field of the browser, enter an IPv6 address-based URL such as
http://[2001:470:1:18::119]
(the equivalent of
http://ipv6.test-ipv6.com
).
2. If the browser successfully navigates to the test URL, stop here, and return to run
the configuration wizard.
3. If the browser could not navigate to the test URL, repeat the preceding steps using
a different browser.
To Next Page
Loading...
Need help?
General