Oracle storagetek sl150 User Manual

Reverting to Factory Default Configuration
4-20 StorageTek SL150 Modular Tape Library User's Guide
After 3-4 seconds, the lighted locator buttons flash slowly. After an additional 5-10
seconds, the locator buttons start to flash rapidly.
6. When the lighted locator buttons start flashing rapidly, release both buttons.
If either locator button is released before t
he light begins to flash rapidly, the reset
process stops.
Otherwise, the library reverts to the factory-default configuration and
shuts down.
7. If the library does not restart automatically, press the power button to start the
library.
The power button is to the right of the locator button and the two status LEDs:
8. Run the installation wizard and reconfigure the library just as you would when
setting up a new unit.
For initial setup instructions, see the StorageT
ek SL150 Modular Tape Library
Installation Manual in the StorageTek SL150 Modular Tape Library Customer
Documentation Library.
For configuration instructions, see Chapter 3, "Loading Media and Running Self
Checks", "Setting the Time, Network Address, and Library Parameters" on
page 4-1, and Chapter 5, "User Administration."

Oracle storagetek sl150 Specifications

General

Brand	Oracle
Model	storagetek sl150
Category	Storage
Language	English