8.15
CVT TRANSMISSION
10. Gear dogs should be square at the corners. Replace
both mating gears if any are rounded.
11. Inspect the shift drum tracks for wear or damage.
Inspect shift fork for bending, and the surface for wear,
burning, or scoring.
12. Inspect the shift fork shaft and all springs. Inspect
detent cam and pawl for wear.
13. Reassemble the drum starting with shaft guide, detent
cam (wide flange faces toward the threaded end of
drum), the flat washer, and snap ring.
14. Place fork shaft through guide with pointed end as
shown.
Inspect Shift Fork
To Next Page
Loading...
Need help?
General
