Polaris RZR PRO XP 2020 User Manual

8.18
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
10.Install and tighten the large clamp
e
using the
appropriate clamp tool.
Axle Boot Clamp Tool: PU-48951
or
CV Boot Clamp Pliers: 8700226
11. While pulling out on the CV shaft, fully extend the CV
joint and slide a straight O-ring pick or a small slotted
screw driver between the small end of the boot and
the shaft. This will allow the air pressure to equalize in
the CV boot in the position that the joint will spend
most of its life. Before you remove your instrument,
be sure the small end of the boot is in its correct
location on the shaft.
12.Install and tighten the small clamp
r
on the boot
using the appropriate clamp tool.
INNER PLUNGING JOINT / BOOT
REPLACEMENT
NOTICE
This procedure applies to the front drive axles only.
1. Use a side cutters to cut and discard the boot clamps
q
.
2. Remove the large end of the boot from the plunging
joint and slide the boot down the shaft.
3. Clean the grease from the face of the joint.
FINAL DRIVE

Polaris RZR PRO XP 2020 Specifications

General

Brand	Polaris
Model	RZR PRO XP 2020
Category	Offroad Vehicle
Language	English