Polaris RZR PRO XP 2020 User Manual

9
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
9.27
STABILIZER BAR REMOVAL /
INSTALLATION
REMOVAL
1. Lift and support vehicle by main frame.
2. Remove rear wheel nuts and wheels.
3. Identify / mark top side of the stabilizer bar to
reference during installation.
4. Remove the fasteners retaining the stabilizer bar to
the linkage
q
on each side of the vehicle.
5. Remove the four fasteners
w
retaining the stabilizer
bar to the vehicle frame.
6. Remove the bushing brackets and bushings for ease
of removal.
7. Carefully remove the stabilizer from the LH wheel well
area of the vehicle.
8. Inspect the stabilizer bar for straightness. Inspect the
pivot bushings and replace if needed.
INSTALLATION
1. Carefully install stabilizer bar through the LH wheel
well area.
NOTE
Be sure fuel lines and shift cable are routed ABOVE the
stabilizer bar.
2. Fully install stabilizer bar, bushings, bracket and
bracket fasteners and stabilizer links. Center
stabilizer bar in the frame. Torque fasteners to
specification (see below).
3. Torque all fasteners to specification (see below).
4. Lubricate stabilizer bar pivot bushings via grease
fitting.
5. Install rear wheels and wheel nuts. Torque wheel nuts
to specification.
TORQUE
Rear Stabilizer Bar Linkage:
44 ft-lbs (60 Nm)
Stabilizer Bar Mounting Bracket Bolts:
30 ft-lbs (40 Nm)
Wheel Lug Nuts:
120 ft-lbs (163 Nm)
STEERING / SUSPENSION

Polaris RZR PRO XP 2020 Specifications

General

Brand	Polaris
Model	RZR PRO XP 2020
Category	Offroad Vehicle
Language	English