EasyManuals Logo
Home>Polycom>Conference System>RealPresence Group

Polycom RealPresence Group User Manual

Polycom RealPresence Group
120 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #114 background imageLoading...
Page #114 background image
2. Touch the RealPresence Group Series System tab.
3. Under Meetings, touch Mute Auto Answer Calls to enable the option.
4. After the call connects, touch Mute when you're ready to unmute the microphones.
Temporarily Refuse Calls
If your system administrator has allowed you access to User Settings, you can set the system to Do Not
Disturb to automatically refuse incoming calls when you do not want to be disturbed. When the system
receives a call, the call is rejected, the caller gets a message that the call was rejected, and you receive
no notification about incoming calls.
You can still place outgoing calls when the system is set to Do Not Disturb.
Procedure
1. From the Home screen, touch .
2. Touch the RealPresence Group Series System tab.
3. Set Auto Answer Point-to-Point or Auto Answer Multipoint Video to Do Not Disturb.
Cameras
You can adjust available cameras in several ways.
Select a Camera
You can use the Polycom Touch Control to select and adjust the main camera or other near-end or far-
end video sources.
You can adjust other auxiliary cameras or far-end cameras that support pan, tilt, and zoom movement, if
supported or enabled.
When you are in camera control mode, you can press and hold a number to save a preset.
Procedure
1. From the Call screen or from the Home screen, touch Cameras.
2. Touch Select Camera, and then touch the camera or other video source you want to use.
3. In a call, touch Cameras > Near or Far to select either near-end or far-end control.
The video source is shown to the call participants.
Adjust Cameras
After you select a camera, you can make some adjustments to enhance the view.
Note: Before you can adjust the EagleEye Director or EagleEye Director II camera systems, you
must turn camera tracking off.
Procedure
1. Touch Cameras > Control Camera.
2. Touch the arrow buttons on the Polycom Touch Control to move the camera up, down, left, or
right.
3. Touch and to zoom out and zoom in.
Using a Polycom
®
Touch Control Device
Polycom, Inc. 112

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polycom RealPresence Group and is the answer not in the manual?

Polycom RealPresence Group Specifications

General IconGeneral
BrandPolycom
ModelRealPresence Group
CategoryConference System
LanguageEnglish

Related product manuals