End a Call
When your call is complete, hang up the call.
Procedure
» On the remote control, press .
Conference Calls
Conference, or multipoint, calls involve at least three different endpoints or sites. All endpoints or sites
can participate in conference calls when using a bridge, such as the RealPresence
®
Collaboration Server
800s, to host the conference call. The number of sites allowed in the call is determined by the capabilities
of the bridge hosting the call. Check with your system administrator to find out how many sites are
allowed in a bridged conference call.
Place a Conference Call
To start a new conference call, you need to start with the first participant or site and then add additional
participants and sites.
Procedure
1. Call the first site.
2. After the call connects, press on the remote control to open the dialing keypad.
3. Place a call to the next site.
4. Repeat the above steps until all sites are connected.
Place a Call during a Conference Call
If you need to, you can hold a conference call and place a new call.
Procedure
1. Press and then on the remote control.
2. Place the call using your preferred method.
Answer a Call during a Conference Call
While in a conference call, you can hold the conference call and answer an incoming call.
Procedure
» Use your remote control to select Hold + Accept to hold the current call and answer the incoming
call.
Note: Depending on the call type, you can resume the conference while an individual
participant in the meeting is on hold.
Using a Polycom RealPresence Group Series Remote Control
Polycom, Inc. 18
To Next Page
Loading...
Need help?
General
