© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 104
Treadmill - Resets to Welcome Screen at Beginning of the
“3…2…1…” Countdown
Description
After pressing "Quickstart" the console will start the "3…2…1…" countdown, but reverts back to the
"Welcome" screen immediately after the "3…"
Possible Causes
1 Stop switch damaged or faulty.
2 Stop switch wiring damaged or faulty.
3 Stop switch stuck in the in the engaged position.
Possible Remedies
1 Replace stop switch.
2 Verify that the cable connectors are seated properly and ohm out the cable for continuity. If an open is
detected in the cable, replace stop switch cable.
3 Replace the stop switch.
To Next Page
Loading...
Need help?
General
