© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 21
This section provides a quick method of checking the proper operation of the P80. Proper operation of the
P80 should be verified at the end of any maintenance procedure. The following procedure assumes a fully
operational console that has been properly installed and connected to video and network sources. In
addition, the console must also have been registered and a channel scan completed.
Procedure
1 Plug the power cord into the wall outlet (or turn on the treadmill with its breaker switch). Verify that
the P80 "Boots Up" to the "Welcome" screen (the boot sequence will take some time).
Figure 15: Welcome Screen
2 Press the "Quick Start" button on the touch screen and verify that the unit starts the manual workout
program.
3 Verify that the machine control lever(s) operate(s) the appropriate machine functions of the
equipment base.
• Press RESISTANCE
(SPEED on a treadmill) lever in the up direction and verify that
resistance level or speed has been increased.
Section 3 - Operation
Verification
To Next Page
Loading...
Need help?
General
