10
ENFORCER V11 PROGRAMMING GUIDE
Text programming
On the system it is possible to label items such as the following:
• Zones – Two labels; zone name and location
• Area names
• Site name
• Keypad/reader – Two labels; keypad description and location
• Zone and output expander location descriptions
• User names
The control panel incorporates a predictive text feature, and works like so:
Enter ‘B’ and ‘Bedroom’ will be displayed. If the word that is required does not appear, then type the word letter by
letter.
Hint: To type a word, press the relevant button the appropriate number of times – e.g. for the letter ‘k’ press 5 two times, or for the letter ‘s’ press 7
four times. For punctuation marks, press the 1 button multiple times until the desired character is shown.
Misc button typing
BUTTON TEXT FUNCTION
a
Toggles between upper and lower case characters
b
Moves cursor left
c
Clears letters / adds a space
d
Moves cursor right
[ ]
Moves the cursor left and right
The internal tag reader
The Internal tag reader can be used for arming/disarming, entry control or access control. Refer to the installation
manual for all connections.
Tag area (where a proximity tag/card must be presented to arm/disarm)
Blue LED
Alert
Amber LED
Alarm
Red LED
Tamper
Red LED
Fault
Amber LED
Disarmed
The external proximity reader
The external proximity reader can be used for arming/disarming, entry control or access control. Refer to the
installation manual for all connections.
To arm/disarm the system using the external proximity reader, present a pre-
programmed tag to the centre of the unit.
The unit will display the system status:
• Green indicates the system is disarmed.
• Red indicates the system is armed.
Present the tag again within 10 seconds to arm or disarm the system.
Please note: The system will arm depending on the type of exit mode programmed (nal door, timed or
push to set)
To Next Page
Loading...
Need help?
General
