25
ENFORCER V11 PROGRAMMING GUIDE
CODES AND USERS
CODES AND USERS?
5 Digit PINs?
Delete Users and Fobs?
Change Duress Codes?
Change Master Manager Code?
Change Engineer Code?
This function changes the Engineer code, the Master Manager code and adds/changes/deletes any Duress or
Guard codes.
Default codes
User: [None] Master Manager: 2222 Engineer: 1111
Please note: User codes, fobs and keyfobs can only be changed in the Master Manager Menu. Please see
the user manual for more information.
5 Digit Pins?
If enabled, all new codes added to the system will require a minimum of 5 digits.
Please note: Any existing 4 digit codes will still be valid.
Delete Users And Fobs
This will delete all the key fobs and user codes from the system.
Please note: that this will not delete the Master Manager and the Engineer codes.
CHANGE DURESS CODES
[2] Duress Code
If the system is unset using a ‘Duress’ code, a silent ‘Duress’ or ‘Hold Up’ signal is sent.
Please note: ACPO policy restricts (it is still OK to use if Police give permission) use of Duress codes for
police call purposes.
[3] Guard Code
A ‘Guard code’ can be used to unset the system only after an alarm has been activated for a minimum time (see
‘Change Timers’ Appendix C). The code will arm a system and an output type is available to signal when this code
is used (0058 Guard Code).
[4] Dial Out
A dial code is used to force the panel to dial out the UDL software while in ‘Day Mode’ (PSTN modem only).
CHANGE MASTER MANAGER CODE
The Master Manager code can be 4, 5 or 6 digits long, or can be assigned to a tag. It may also have the following
functions:
[0] Unset / Set [1] Unset Only [2] Set Only [3] None (menu access)
Flexi Set
If enabled, the default area the device is assigned to, will set. If disabled, the default area will be shown on the
display, and from here other areas can be selected.
To Next Page
Loading...
Need help?
General
