To Next Page

To Previous Page

ENFORCER V11 PROGRAMMING GUIDE

ALARM RESPONSE OPTIONS

Silent 1st Alarm

If this function is selected as ‘conrmed’, then the rst alarm to activate on the system will be silent, but only if

another zone activates (i.e. a conrmed alarm) then the alarm will activate and the alarm tones will be heard. This

option is only valid once the system has been armed for 3 minutes and not if the entry time has started.

Disable Conrm On Entry

To comply with BS8243 clauses 6.4.3 and 6.4.4, this option should be set to YES to disable conrmation once the

entry procedure has started. For use with BS8243 option 6.4.5, this option should be ‘No’. If ‘Disable Conrm On

Entry’ is set to YES this option will disable ALL conrmation signals on entry. If NO the conrmation signals are

enabled on expiry of entry time.

Alarm Starts / Stops (Alarm Responses)

Area # start at

This programs where the alarm response for each area starts.

Area # stop at

This programs where the alarm response for each area escalates to.

The following options have the same ‘start at’ and ‘stop at’ using the same format at described earlier:

• Fire

• Gas

• PA

• Medical

• 24 Hour

Any Alarms Start

This option allows alarms to start at a dierent place previously programmed if multiple areas are armed.

For example, if 24 hour is programmed to ‘start at internal sounders’ and ‘stop at internal sounders’, this feature is

programming as ‘Internal Sounders’ and the next option has areas A, B and C entered. If A, B and C are armed and

a 24 Hour zone is triggered, the alarm would start with the internal sounders and keypads being audible.

If Areas Armed

Select the areas that the previous option will be applicable to.

Any Alarms Stop

This option allows alarms to stop at a dierent place previously programmed if multiple areas are armed.

For example, if 24 Hour is programmed to ‘Start at keypad’ and ‘stop at internal sounders’, this feature is

programming as ‘Bells only’ and the next option has areas A, B and C entered. If A, B and C are armed and a 24

Hour zone is triggered, the alarm would escalate to the external bells.

If Areas Armed

Select the areas that must be armed at the same time for the previous option setting to become active.

Pyronix ENFORCER V11 Programming Guide

Other manuals for Pyronix ENFORCER V11