QRP Labs QMX Assembly Manual

2.7 Install 47uH inductors
Install the four 47uH axial inductors L505, L507, L509, and L514. Bend one lead over 180-degrees
so that the inductor body stands up vertically at 90-degrees to the PCB.
The orientation of these is not particularly important, but my recommendation is to follow the
silkscreen PCB pattern, putting the body (longer lead) nearer to the PCB lower edge (as orientated
in the diagram below) and the wire (shorter lead) nearer to the top side.
QMX assembly Rev 1.00e 25

QRP Labs QMX Specifications

General

Brand	QRP Labs
Model	QMX
Category	Transceiver
Language	English