Chapter 2 Installation and Configuration
Configuration
SuperLoader User’s Guide 31
To Disconnect Power from AC Mains: 2
1 Press the power switch on the front panel and hold for approximately
five seconds.
2 When the LCD screen goes blank, push the AC power switch on the
back of the SuperLoader to the
OFF position (the 0 is pressed).
The configuration submenu has the following options:
Figure 21 Submenu
for Configuration
Note: The SuperLoader power inlet serves as the disconnect
device.
#ONFIGURATION
3#3))$
%THERNET
3ET)0
$(#0
3TATIC)0
3ET3UBNET-ASK
3ET'ATEWAY
3ET3.-03ERVER
3ET4IME3ERVER
#ONFIGURATION
3#3))$
%THERNET
3ET)0
$(#0
3TATIC)0
3ET3UBNET-ASK
3ET'ATEWAY
3ET3.-03ERVER
3ET4IME3ERVER
4IME
3ET4IMEZONE
3ET$ATE4IME
#HANGE-ODE
2ANDOM
3EQUENTIAL
3EQ#YCLE-ODE
#LEANING4APE
!UTO#LEAN
4APE,OCATION
#OMPRESSION
3ECURITY
3ECURITY
3ET0ASSWORD
/PERATOR
!DMINISTRATOR
3YSTEM5PDATE
#ONFIGURATION
3#3))$
%THERNET
3ET)0
$(#0
3TATIC)0
3ET3UBNET-ASK
3ET'ATEWAY
3ET3.-03ERVER
3ET4IME3ERVER
3#3))$$RIVE
3#3))$,OADER
3ET3PEED
-BPS
-BPS
!UTO.EGOTIATE
4IME
3ET4IMEZONE
3ET$ATE4IME
#HANGE-ODE
2ANDOM
3EQUENTIAL
3EQ#YCLE-ODE
#LEANING4APE
!UTO#LEAN
-AGAZINES
3ECURITY
3ECURITY
3ET0ASSWORD
/PERATOR
!DMINISTRATOR
3YSTEM5PDATE
"OTH
,EFT
2IGHT
4IME
3ET4IMEZONE
3ET$ATE4IME
#HANGE-ODE
2ANDOM
3EQUENTIAL
3EQ#YCLE-ODE
#LEANING4APE
!UTO#LEAN
-AGAZINES
3ECURITY
3ECURITY
3ET0ASSWORD
/PERATOR
!DMINISTRATOR
3YSTEM5PDATE
2ESTORE-FG$EFAULT
"OTH
,EFT
2IGHT
4APE,OCATION
#OMPRESSION
SuperLoader DLT/SDLT (prior to v45) SuperLoader LTO
To Next Page
Loading...
Need help?
General