EasyManuals Logo
Home>Quasimidi>Electronic Keyboard>Sirius

Quasimidi Sirius User Manual

Quasimidi Sirius
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #80 background imageLoading...
Page #80 background image
Presetting the Gain-Control:
Easy-Mode:
The Gain-control allows you to determine the input sensitivity of the built-in microphone pre-
amplifier. The control is located on the right of the rear panel of the Sirius. Turn the Gain-control to
the middle setting (12 o´clock position).
If you have connected the Sirius to an audio-unit such as a stereo system or instrument amplifier,
turn the volume control of your amplifier to minimum for the time being.
The Vocoder works with 16 basic programmes which can of course be changed if required. To get a
first impression these basic programmes can be tried first. The microphone is the analyse source in
this "Easy-Mode". A Carrier is automatically set you only have to speak into the microphone and
don´t have to press any keys on the keyboard.
You require some pre-settings for the Easy-Mode. Should you however have initialised your Sirius as
described at the beginning of this Manual and select a Song without Vocoder-settings (for example
Nr.1 "Saturn") you can leave out the following procedure. Skip on to "Selecting Basic Programmes".
1. The CARRIER-EXT.-key in the VOCODER-panel of the Sirius must be switched off.
2. No Part of the Sirius must be selected as Carrier. You will recognise that the CARRIER-key in the
Vocoder-panel is not lit. If the key is lit, you can change the setting as follows: When you hold down
the CARRIER-key, the Part-keys under the dials in the MIXER-panel will show you which Parts are se-
lected as Carriers. A lit key indicates that this part is a Carrier for the Vocoder. While you still hold
down the CARRIER-key turn off all lit keys below the dials one after the other. Now you have de-
activated all internal Carrier signals.
To select the basic programme 1 "Robot Voc" (Robot-Vocals), first hold down the Vocoder-key in the
MIXER-panel. The display will show:
Caution: Pre-settings for the Easy Mode:
Selecting Basic Programs:
The Vocoder
80
CARRIER-IN ANALYSE-IN GAIN
Gain-Control
32 OHM32OHM
NATURAL
DRUMS
BASS-
SOUNDS
DIRTY
NATURAL
DIRTY
BASS
ELECTRONIC
DRUMS
PAD-
SOUNDS
909-TYPE
PLUCKED
SOUNDS
808-TYPE
LEVEL
BD SNARE HIHAT PERC. SYNTH 1 SYNTH 2 SYNTH 3
MOD.-WHEEL
ASSIGN
PART
SELECT
SOUND
SELECT
MODULATION
WHEEL
PITCH
BEND
TRACK-MUTING
PATTERN
SELECT
SONG
SELECT
PART
MUTE
PART/SEQ.
TO MIDI
PANORAMA FX1/FX2
12
SNARE HIHAT
DETUNE FILTER-
OVERDRIVE
Q-FACTOR VCF-EG
MACRO
VCA-EG
MACRO
MOD.-
DEPTH
MOD.-
RATE
SPECIAL-LOOP
TRACK-FADER
OVERBLAST
MOD.-
MACRO
WAVE-
MACRO
GLIDE
LPF 24 dB RELEASE
0
32
64
96
127
LPF 12 dB
HPF 12 dB
PAGE/BANK
MASTER
OLUME
MICROPHONE
CONNECTOR
VALUE
TEMPO
RECALL EXIT
EDIT WRITE
SHIFT
KEY-TRACKINGOCTAVE-UPOCTAVE-DO VCF-DYN. VCA-DYN. RANDOM-SOUND
PRESS BUTTON
FOR SOUND-CREATION
TAP-
TEMPO
DEMO
SYNC.
EXTERN
AUDIO
SYNC
CUTOFF ENV.-MOD VCA
LEVEL
PERCUSSION
PATTERN BREAK SPECIAL LOOPTRACKS
SYNTH 1 SYNTH 2 SYNTH 3 VOCODER
HOLD BUTTON AND
SELECT PART
ANALYSE CARRIER CARRIER-EXT. MICRO.
HOLD
TO
SELECT
REW
ARPEG.
ON/OFF
START
SONG-STEP
STOP
FWD
PHONES
KICK/BD
3 4 5 6 7 8 9 10 11 12 13 14 15 16
SOLO-
SOUNDS
DRUM-SFX
EFFECT-
SOUNDS
SIRIUS
SIRIUS
by QUASIMIDI
CATEGORIES
MIXER 11CHANNELVOCODER SEQUENCER
MODULATOR OSCILLATORS RESONANCE-FILTER
AMPLIFIER
EG-MACROS PHONETISCHERSPEKTRALTRANSFORMATOR
RECORD
Caution:
The initialisation
will delete the en-
tire ram memory
of the Sirius and
all settings will re-
vert to the original
factory settings.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Quasimidi Sirius and is the answer not in the manual?

Quasimidi Sirius Specifications

General IconGeneral
BrandQuasimidi
ModelSirius
CategoryElectronic Keyboard
LanguageEnglish