8.7.6 India WPC
Operation of the equipment is only allowed under India WPC GSR‐38 for 5.8GHz band
regulation configuration.
8.7.7 Brazil
The equipment will operate only in the frequency bands 5470 ‐ 5725 MHz and 5725 ‐ 5850
MHz. The software version to be sold in Brazil with blocking is from version 4.6. The power
supplies presented in this user manual are not sold with this product.
O equipamento irá operar apenas nas faixas de frequências 5470 ‐ 5725 MHz e 5725 ‐ 5850
MHz. A versão do software a ser comercializado no Brasil com bloqueio é a partir da versão
4.6.
As fontes de alimentação apresentadas neste manual não serão comercizliadas junto com
este produto.
8.7.8 For Norway and Sweden only
Equipment connected to the protective earthing of the building installation through the mains
connection or through other equipment with a connection to protective earthing ‐ and to a
cable distribution system using coaxial cable, may in some circumstances create a fire
hazard. Connection to a cable distribution system has therefore to be provided through a
device providing electrical isolation below a certain frequency range (galvanic isolator, see
EN 60728‐11).
8.7.9 Norway
Utstyr som er koplet til beskyttelsesjord via nettplugg og/eller via annet jordtilkoplet utstyr ‐
og er tilkoplet et kabel‐TV nett, kan forårsake brannfare. For å unngå dette skal det ved
tilkopling av utstyret til kabel‐TV nettet installeres en galvanisk isolator mellom utstyret og
kabel‐ TV nettet
8.7.10 Sweden
Utrustning som är kopplad till skyddsjord via jordat vägguttag och/eller via annan utrustning
och samtidigt är kopplad till kabel‐TV nät kan i vissa fall medföra risk för brand. För att
undvika detta skall vid anslutning av utrustningen till kabel‐TV ät gal‐ vanisk isolator finnas
mellan utrustningen och kabel‐TV nätet.
8.7.11 Unregulated
In countries where the radio is not regulated the equipment can be operated in any
regulation configuration, best results will be obtained using Universal regulation
configuration.
8.7.12 Safety Practices
Applicable requirements of National Electrical Code (NEC), NFPA 70; and the National
Electrical Safety Code, ANSI/IEEE C2, must be considered during installation.
To Next Page
Loading...
Need help?
General