Corporate Headquarters | T. +972.3.766.2900 | E. sales@radwin.com | www.radwin.com
Figure 61 Tighten bolt as shown
7.2.5 Fine Alignment of the RT‐A(HBS)/Hub
To improve the alignment, RADWIN recommends that you repeat the above alignment
procedure for the RT‐A(HBS)/Hub opposite the RT‐B(HSU)/Client based on RSS level
measurements.
7.3 Aligning RADWIN 2000 E ODUs
Antenna alignment is performed while the Client is not Registered. At this state, the link MCS
and TX power are kept constant, allowing the installer to evaluate the RSS while they rotate
the antenna, to get the optimal signal level.
To Next Page
Loading...
Need help?
General