6.2 Before using your product
Commissioning
Before using your autopilot system for the rst time
you must ensure that the system has been correctly
commissioned in accordance with the supplied
documentation.
6.3 Powering the Pilot controller on
1. Press and hold the STANDBY button for one
second, until the logo appears.
If the unit is being switched on for the rst time
or after a factory reset the set up wizard will be
launched.
Note: The logo is not displayed if the unit is in
'sleep mode'. In Sleep mode the unit may appear
off but still has power.
2. To turn the Pilot controller off press and hold the
STANDBY button. After 1 second a pop up count
down is displayed.
3. Continue to hold the STANDBY button for a
further 3 seconds to complete the power off.
Note: You cannot power off the Pilot controller
whilst the Autopilot is engaged.
Getting started
33
To Next Page
Loading...
Need help?
General
