Troubleshooting
106
4
❖
❖❖
❖ Connect Copy
You do not have the
privileges to use
the following
function(s).
The use of this function is
restricted to authenticated
users only.
Contact the administrator.
Message Causes Solutions
Cannot connect to
the sub-machine.
Check the status
of the sub-ma-
chine.
The L
LL
L indicator is lit. Press [Exit] on the main machine
and follow the instructions on the
display.
The hard disk of the sub-
machine is malfunctioning.
Cannot print from
the sub-machine.
Check the status
of the sub-ma-
chine.
A paper misfeed has oc-
curred on the sub-machine,
or toner or other supplies
need to be replenished.
Follow the instructions displayed.
Reference
“Adding Toner”, General Settings
Guide
“Clearing Misfeeds”, General
Settings Guide
“Loading Paper”, General Set-
tings Guide
If the sub-machine's display indi-
cates that a cover is open, follow the
instructions shown.
The User Tools menu of the
sub-machine is open.
Press the {
{{
{User Tools/Counter}
}}
} key to
close the User Tools menu.
Sub-machine is in
Interrupt mode.
The sub-machine is in In-
terrupt mode.
Press the
{
{{
{Interrupt}
}}
}
key on the sub-
machine to exit Interrupt mode. See .
Sub-machine does
not have the same
paper setting(s).
Paper type or tray settings
on the two machines do not
match.
Make the same settings on both ma-
chines.
The Cover Sheet
setting(s) of the
sub-machine is
different from the
main machine.
Cover settings on the two
machines do not match.
The Slip Sheet
setting(s) of the
sub-machine is
different from the
main machine.
Slip Sheet settings on the
two machines do not
match.
The Chapter set-
ting(s) of the
sub-machine is
different from the
main machine.
Chapter settings on the two
machines do not match.
Message Causes Solutions
MartiniC2_EN_Copy-F1_FM.book Page 106 Tuesday, July 27, 2004 1:43 PM
To Next Page
Loading...
Need help?
General
