Other Print Operations
94
4
Spool Printing
Spool Printing allows print jobs transferred from a computer to be temporarily
stored, and then prints them after they are transferred. This shortens printing
time as it maximizes printer efficiency.
Important
❒ During Spool Printing, the hard disk is accessed and the Data-In indicator
blinks. Turning off the computer or machine during Spool Printing can dam-
age the hard disk. Also, if the computer or machine is turned off during Spool
Printing, spooled jobs will be deleted. Therefore, do not turn the power to the
computer or machine off during Spool Printing.
Limitation
❒ If data is sent to the machine using other protocols besides diprint, lpr, ipp,
and smb , Spool Printing cannot be performed.
❒ Up to a maximum of 150 jobs at once can be spool printed.
Note
❒ Printing the first page with Spool Printing will be slow.
❒ The computer requires less print processing time when large amounts of data
are spooled.
❒ Stored spool jobs can be viewed or deleted using a Web browser.
-
--
-Viewing/Deleting spool jobs in a Web browser
Start the Web browser and enter the machine's IP address in the address bar.
This displays the top page.
For more information, see Network Guide.
-
--
-Setting Spool Printing
Spool Printing can be set using telnet or a Web browser.
• Using a Web browser
See Network Guide or Help for more information.
• Using telnet
Type in “spoolsw spool on” to set Spool Printing.
See Network Guide for more information about telnet.
MartiniC25-EN-Pref-F_FM_ZF.book Page 94 Tuesday, July 27, 2004 11:51 AM
To Next Page
Loading...
Need help?
General
