Remote Maintenance by telnet
93
4
rendezvous
Use the “rendezvous” command to
display rendezvous-related settings.
❖
❖❖
❖ View settings
Rendezvous settings are dis-
played.
msh> rendezvous
❖
❖❖
❖ Current computer name display
msh> rendezvous cname
❖
❖❖
❖ Display information about the current
printer location
msh> rendezvous location
❖
❖❖
❖ Rendezvous computer name setting
You can specify the rendezvous
computer name.
msh> rendezvous cname
“computer name”
• The computer name can be en-
tered using up to 63 alphanu-
meric characters.
❖
❖❖
❖ rendezvous Installation location infor-
mation setting
You can enter information about
the location where the printer is in-
stalled.
msh> rendezvous location
“location”
• Information about location can
be entered using up to 32 alpha-
numeric characters.
❖
❖❖
❖ Setting order of priority for each pro-
tocol
• diprint
msh> rendezvous diprint
[0–99]
• lpr
msh> rendezvous lpr [0–
99]
• ipp
msh> rendezvous ipp [0–
99]
You can specify the order of prior-
ity for “diprint”, “1pr”, and “ipp”.
Smaller numbers indicate higher
priority.
❖
❖❖
❖ IP TTL setting
msh> rendezvous ipttl {1-
255}
You can specify the IP TTL (the
number of routers a packet can
pass through).
Note
❒ The default is 255.
❖
❖❖
❖ Resetting the computer name and lo-
cation information
You can reset the computer name
and location information.
msh> rendezvous clear
{cname | location}
• cname
Reset the computer name. The
default computer name will be
displayed when the computer is
restarted.
• location
Reset the location information.
The previous location informa-
tion will be deleted.
To Next Page
Loading...
Need help?
General
