Printing with the Finisher
87
4
Printing with the Finisher
You can collate, staple or punch holes in printed paper by installing the optional
finisher. Make sure you read the following precautions when using the optional
finisher:
Reference
For information about optional finishers, see General Settings Guide.
To use the staple function, see p.88 “Staple”.
To use the punch function, see p.90 “Punch”.
To use the Z-fold function, see p.92 “Z-fold”.
❖
❖❖
❖ Be sure to make settings for options installed on the machine in the printer drivers.
Reference
To make settings for options in the printer drivers, see p.58 “Making Op-
tion Settings for the Printer”.
❖
❖❖
❖ Be sure to set the paper size and paper orientation in the printer driver when using
duplex printing, booklet, combine (layout), staple and punch functions.
Reference
For information about duplex printing, booklet, and layout, see the printer
driver Help.
To use the staple function, see p.88 “Staple” and the printer driver Help.
To use the punch function, see p.90 “Punch” and the printer driver Help.
To use the Z-fold function, see p.92 “Z-fold” and the printer driver Help.
Note
❒ Depending on the application, print settings may not be enabled and printed
output may not be as expected.
❖
❖❖
❖ When setting staple or collate in the printer driver, make sure that the Collate check
box is cleared in the application's [Print] dialog box.
If Collate is enabled in the application, printing will not be as intended.
MartiniC25-EN-Pref-F_FM_ZF.book Page 87 Tuesday, July 27, 2004 11:51 AM
To Next Page
Need help?
General
