Other Print Operations
90
4
❒ Staple printing will be canceled under the following conditions:
• If the number of staple jobs exceeds maximum. For information about the
maximum number, see “Specifications”, General Settings Guide.
• If a paper size that cannot be stapled is selected. For information about pa-
per sizes that can be stapled, see “Specifications”, General Settings Guide.
• If positions other than those fixed for stapling are specified.
• If there are inconsistencies between the orientation in duplex mode and the
staple position.
• If paper sizes are mixed when a different paper size is specified during a
print job.
• When staples have run out.
• When feeding paper from the bypass tray.
• When staples have run out and Auto Continue is set, printing will continue
without stapling after the message has been displayed.
Punch
With the optional finisher installed, holes can be punched into printed output.
Punch Position
The specified punch position varies depending on paper feed and print data ori-
entation. The following table shows punch positions:
Paper Orientation
on the Machine
Print Data
Direction
Punch Position
Vertical
Vertical
Horizontal
Horizontal
2 holes
3 holes
4 holes
AEW008S
MartiniC25-EN-Pref-F_FM_ZF.book Page 90 Tuesday, July 27, 2004 11:51 AM
To Next Page
Loading...
Need help?
General
