Rinstrum R320 Reference Manual

Reference Manual V1.19 Software Versions 4.xx
003R-682-119 Page 59
15. Special Functions Key – K35*
15.1. Introduction
The K35* firmware allows for the <FUNCTION> key to be configured to a range of
special functions. As the K356 firmware allows for setpoints, there is an additional
special function available where the key can be used to gain access to the setpoint
threshold values.
Refer to KEY.FN
(Key Functions) page 36 to configure the function key.
When leaving the factory, the <FUNCTION> key is blank and has no function pre-
programmed. Each function has an associated overlay sticker supplied that should
be applied to the function key to label the function. Ensure the keypad is clean and
dry before affixing the sticker. Refer to Cleaning page 8 for more information.
15.2. Key Functions
15.2.1. NONE
When set to NONE the special function key is not used during normal operation. This is the
default setting.
15.2.2. TEST
Press the <TEST> key to clear the display then show all segments of the display then
clear the display again before returning to normal operation.
15.2.3. COUNT
Use this key to perform pieces counting. Press the <COUNT> key to switch between weight
display and counts display. The instrument annunciator shows p for pieces.
To record a new sample, do the following:
Tare off any containers.
Place the sample on the scale
Press and hold the <COUNT> key for two seconds. The default number of items in the
sample will be displayed.
Use the <SEL> and <EDT> keys to alter the number of items.
Press <OK> and the current sample will be stored against the entered items.
If printing is enabled the sample quantity and weight will be printed.
15.2.4. UNITS
Use the <UNITS> key to switch the displayed reading between lb and kg. This will affect the
displayed and printed weight but will not affect any data entry. The following is a sample of a
printout displaying kg and lb.
000009 06/05/2003 16:31
2.8 kg G
000010 06/05/2003 16:31
6.1 lb G
NOTE: in K35x, if extended unit switching is enabled it will switch the reading between kg, lb,
oz, and g.

Rinstrum R320 Specifications

General

Brand	Rinstrum
Model	R320
Category	Accessories
Language	English