Rinstrum R320 Reference Manual

Reference Manual V1.19 Software Versions 4.xx
Page 72 003R-682-119
20. Error Messages
A number of error messages may be displayed to warn of operation outside of the acceptable limits.
These messages are described below. Short messages (XXXXX) will appear as a single message
on the display. Longer messages (XXXXX) (YYYYY) will appear on the display in two parts, first the
(XXXXX) part, then the (YYYYY) part.
20.1. Weighing Errors
These messages show status messages or errors that may occur during normal weighing operation.
Error
Description
Resolution
(U - - - - -)
The weight is below the minimum allowable
weight reading.
Increase the weight or decrease
the minimum allowable weight
reading.
(O - - - - -)
The weight is above the maximum
allowable weight reading.
Warning - overloading may damage
mechanical scale elements.
Check the condition of load cell
connections. Check for damaged
load cell.
(ZERO)
(ERROR)
The weight reading is beyond the limit set
for Zero operation. The operation of the
<ZERO> key is limited in the setup during
installation. The indicator cannot be Zeroed
at this weight.
Increase the Zero Range
(Z.RANGE) or use the <TARE>
key instead.
(STABLE)
(ERROR)
Scale motion has prevented a <ZERO> or
<TARE> operation from occurring on
command.
Try the operation again once the
scale is stable.

Rinstrum R320 Specifications

General

Brand	Rinstrum
Model	R320
Category	Accessories
Language	English