Getting Ready
19
Performance
Functions
Editing
Sequencer
(Creating Songs)
Sampler Pads DAW
Appendix
Overview Performing SettingsOverview
Turning the Power On/O
Once everything is properly connected (p. 8), be sure to follow the procedure below to turn on their power. If you turn on equipment in the wrong
order, you risk causing malfunction or equipment failure.
Turning the Power On
* Before turning the unit on/o, always be sure to turn the volume down. Even with the volume turned down, you might hear some sound when
switching the unit on/o. However, this is normal and does not indicate a malfunction.
1. Turn the power on in the following order: the FA connected devices.
On
O
2. Turn the [VOLUME] knob to adjust the volume.
Turning the Power O
1. Turn the power o in the following order: connected devices the FA.
Playing the Demo Songs
The SD card included with this unit contains demo songs.
1. Press the [ ] button.
Demo song playback starts.
2. Press the [ ] button to stop.
* Use of the demo songs for any purpose other than personal enjoyment without
permission from the copyright holder is prohibited by law.
Concerning the Auto O function
The power to this unit will be turned o
automatically after a predetermined amount
of time has passed since it was last used for
playing music, or its buttons or controls were
operated (Auto O function). If you do not
want the power to be turned o automatically,
disengage the Auto O function.
• Any settings that you are in the process
of editing will be lost when the power is
turned o. If you have any settings that
you want to keep, you should save them
beforehand.
• To restore power, turn the power on again.
Selecting a song
1.
Press the [SONG SELECT] button.
The SONG SELECT screen appears.
2. Turn the dial to select a song.
3. Press the [7] (Load) button.
A conrmation message appears.
4. Press the [6] (OK) button.
The song is selected.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
