Editing the Song
72
Adjusting the Pan and Volume
Balance (Mixer)
In the MIXER screen you can adjust the song’s pan and volume
balance for each track.
* The parameters that you edit in the MIXER screen are saved in
the studio set. If you want to keep the changes you make in the
MIXER screen, save the studio set (p. 45).
1. In the SEQUENCER screen (p. 59), hold down the [SHIFT]
button and press the [2] (Mixer) button.
The MIXER screen appears.
MEMO
You can also access the MIXER screen by holding down the
[SHIFT] button and pressing the [SEQUENCER] button.
2. Use the cursor buttons to select a parameter, and use the
dial to edit the value.
About the MIXER screen
2
3
4
5
6
1
No. Explanation Page
1
Part number –
2
Mute and solo settings p. 63
3
Chorus (Chorus Send Level) setting p. 52
4
Reverb (Reverb Send Level) setting p. 52
5
Pan setting p. 44
6
Volume (Level) setting p. 44
Erasing the Song in the Temporary
Area (Song Clear)
Here’s how to erase the performance data that’s in the temporary
area (p. 14).
1. In the SEQUENCER screen (p. 59), hold down the [SHIFT]
button and press the [3] (Song Util) button.
The SONG UTIL MENU window appears.
2. Move the cursor to “Song Clear,” and press the [7] (Select)
button.
A conrmation message appears.
If you decide to cancel, press the [7] (Cancel) button.
3. Press the [6] (OK) button.
The performance data is erased.
Assigning a Name to the Song (Song
Name)
Here’s how you can assign a name to the song.
1. Access the SONG UTIL MENU window.
2. Move the cursor to “Song Name” and press the [7]
(Select) button.
The SONG NAME window appears.
3. Specify the desired name (p. 45).
MEMO
If you want to keep the song, save it on an SD card (p. 74).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
