Sampling
80
Setting the Input Volume (Input
Setting)
Here’s how to set the input volume for the device that’s connected
to the AUDIO INPUT jack or the USB COMPUTER port.
1. In the SAMPLING STANDBY screen (p. 79), press the [2]
(Input Setting) button.
The SYSTEM EFFECTS screen appears.
2. Use the cursor buttons to select a parameter, and use the
dial to change the setting.
Tab Parameter Value
Audio Input Audio Input Level 0–127
USB Audio USB Audio Input Level 0–127
MEMO
You can also access the SYSTEM EFFECTS screen from the
EFFECTS EDIT screen (p. 52).
Moving/Copying a Sample (Clip
Board)
You can move or copy a sample to another pad.
Moving a Sample
1. While holding down the pad that contains the sample you
want to move, press the [CLIP BOARD] button.
2. While holding down the [CLIP BOARD] button, press the
move-destination pad.
The sample is moved.
* If the move-destination pad contains a sample, the message
“Overwrite?” appears. If you want to overwrite, press the [6]
(OK) button; if you decide to cancel, press the [7] (Cancel)
button.
Copying a Sample
1. While holding down the [SHIFT] button and the pad that
contains the sample you want to copy, press the [CLIP
BOARD] button.
2. While holding down the [CLIP BOARD] button, press the
copy-destination pad.
The sample is copied.
* If the copy-destination pad contains a sample, the message
“Overwrite?” appears. If you want to overwrite, press the [6]
(OK) button; if you decide to cancel, press the [7] (Cancel)
button.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
