109
Editing songs (Song Edit)
Song mode
This operation clears all the previously entered steps, so the song is
in an empty state. This is convenient when you want to create a song
from scratch.
All of the song data will be lost when you execute the Initialize
operation. Please note that you can’t use Undo to recover from
this operation.
1.
Press [SONG] to enter Song mode.
2.
Select the song that you want to initialize (p. 106).
3.
Hold down [SHIFT] and press keyboard pad [16].
You’ll be asked to confirm your choice.
fig.05-013
4.
Press [ENTER] once again.
The song will be initialized.
* To cancel, press [EXIT].
5.
If you want to save the song, press [WRITE].
If you don’t save the song, the settings will revert to their prior
state when you turn off the power.
“Saving a song”
(p. 110)
You can edit the level, pan, key shift, reverb, mute, and tempo
settings for each step.
* You must stop song playback before you perform song editing
operations.
* These operations store the setup parameters of each pattern as song
data; they do not affect the setup data of the original patterns.
* If the system setting Song Play mode is set to “MODE2” (p. 119), the
setup parameters of the next step will be ignored if the next step plays
the same pattern as the currently playing pattern.
1.
Press [SONG] to enter Song mode.
2.
Select the song that you want to edit (p. 106).
3.
Hold down [SHIFT] and press keyboard pad [13].
The song mixer screen will appear.
fig.05-014
4.
Use [BWD] [FWD] to select the step whose setup
parameters you want to edit.
* During song editing, you won’t proceed to the next step
automatically.
5.
Press [PART] (SELECT/MUTE) so it is not lighted, and press
the part button [1]–[16] of the part you want to edit.
6.
Set the parameters as desired.
Use [CURSOR ] to select a parameter, and turn the
VALUE dial or use [INC] [DEC] to set the value.
7.
Set the part mute status as desired (p. 45).
8.
Set the tempo (p. 44).
* For details on the various setup parameters, refer to
“Parameters
that change when the pattern changes (Setup parameters)”
(p. 43).
9.
If you want to save the song, press [WRITE].
If you don’t save the song, the settings will revert to their prior
state when you turn off the power.
“Saving a song”
(p. 110)
Initializing a song (INITIALIZE)
Song mixer (SONG MIXER)
MC-808_r_e.book 109 ページ ２００７年７月１７日 火曜日 午後５時１分
To Next Page
Loading...
Need help?
General
