123
System mode
System Mode
*: V-LINK compatible devices such as the EDIROL DV-7PR/P-1 use only Note Tx Ch A.
When using EDIROL motion dive .tokyo console edition, Note Tx Ch has the following correspondences:
A: The MIDI channel that controls section A
B: The MIDI channel that controls section B
C: The MIDI channel that controls the MIDI note plug-in
Settings related to V-LINK (V-LINK)
Parameter
Range Description
Note Tx Ch A
1–16 Specifies the MIDI channels on which V-LINK devices will be controlled. (*)
Note Tx Ch B
Note Tx Ch C
D Beam Assigns a V-LINK function to the D Beam controller.
OFF The operation selected by [D BEAM] will occur regardless of whether V-LINK
is on or off.
ColorEQ Fore CC1 (Modulation) These are used by EDIROL motion dive .to-
kyo console edition.
ColorEQ Back CC71 (Resonance)
Scratch SW CC3
Speed Knob CC8 (Balance)
Total Fader CC10 (Panpot)
Cross Fader CC11 (Expression)
BPM Sync SW CC64 (Hold)
Clip Loop SW CC65 (Portamento)
Assign Knob CC72 (Release)
Fade Time SW CC73 (Attack)
Visual Knob CC74 (Cutoff)
AB SW CC81 (General-6)
Tap SW CC83 (General-8)
Total Select CC85
FX Select CC86
Play Pos CC91 (Reverb)
LoopStartPos CC92 (Tremolo)
Loop End Pos CC93 (Chorus)
LayerModeSel CC94 (Celeste)
Dissolve Time CC73 (Attack) These are used by devices such as the ED-
IROL DV-7PR.
Color Cb CC1 (Modulation)
Color Cr CC71 (Resonance)
Brightness CC74 (Cutoff)
VFX1 CC72 (Release)
VFX2 CC91 (Reverb)
VFX3 CC92 (Tremolo)
VFX4 CC93 (Chorus)
Output Fade CC10 (Panpot)
MC-808_r_e.book 123 ページ ２００７年７月１７日 火曜日 午後５時１分
To Next Page
Loading...
Need help?
General
