95
Editing rhythm sounds (Rhythm Edit)
Patch/Sample mode
The patch/rhythm set settings you edit will be lost if you reselect the patch/rhythm set or turn off the power. If you want to keep the
changes you made, save them as described here.
All of the MC-808’s rhythm sets are rewritable.
In other words, when you save a rhythm set, the rhythm set data that previously occupied the save destination will be overwritten and lost.
However, you can restore the factory-set internal data by carrying out a Factory Reset (p. 25).
1.
In Patch/Sample mode, select the rhythm set that you want
to save.
fig.04-028.e
2.
Press [WRITE].
The rhythm name entry screen will appear.
fig.04-022
3.
Assign a name to the rhythm set.
Range:
space, A–Z, a–z, 0–9, ! “ # $ % & ‘ ( ) * + , - . / : ; < = >
? @ [ ¥ ] ^ _ ` { | }
→ ←
4.
When you have finished entering the name, press [ENTER].
A screen will appear in which you can select the write-
destination rhythm set.
fig.04-023
* To cancel, press [EXIT].
5.
Press [USER] or [CARD] to select the group into which the
rhythm set is to be written.
[USER]
User group (Usr)
The rhythm set will be saved in internal memory.
[CARD]
Card group (Crd)
The rhythm set will be saved on the card.
* You can’t use the Card group unless a separately sold CompactFlash
card is inserted.
6.
Turn the VALUE dial or use [INC] [DEC] to select the write-
destination rhythm set.
The number and name shown in the display will change.
Range:
UsrA:001–128, UsrB:001–128
CrdA:001–128, CrdB:001–128
7.
Press [ENTER].
You’ll be asked to confirm your choice.
8.
To write the data, press [ENTER].
* To cancel, press [EXIT].
If the samples used by the patch have not been saved, those
samples will be saved automatically.
Saving a rhythm set
Button Description
[CURSOR ]
Moves the cursor (the location at
which to enter/edit a character).
Hold down [SHIFT]
and press [INC] or
[DEC]
Switches letters between uppercase
and lowercase.
Hold down [SHIFT]
and press [UNDO/
ERASE]
Inserts a space at the cursor location.
VALUE dial,
[INC] [DEC]
Selects characters.
[UNDO/ERASE] Deletes the character at the cursor lo-
cation, while shifting the following
characters to the left, closing the gap.
This will appear when you edit the rhythm set.
If the destination indicates “Data
Protected!” when you attempt to save
If the bank in which you’re attempting to save the patch is
protected, the following screen will appear and you won’t be
able to save the patch.
fig.04-030
Either save the patch in a bank that’s not protected, or turn off
the Protect setting (p. 126).
* With the factory settings, only “UsrH” (Patch) and “UsrB”
(Rhythm set) is unprotected.
MC-808_r_e.book 95 ページ ２００７年７月１７日 火曜日 午後５時１分
To Next Page
Loading...
Need help?
General
