8
8-13. Emergency Operation
Use [Emergency Operation] in the following situations when there is an urgent need.
• When the remote control's batteries have failed.
• When the remote control is broken.
• When the remote control is lost.
*1 Figures: RCS-SH80BG.WL and RCS-TRP80BG.WL are of receivers (inside indoor unit), RCS-SS80BG.WL is
of the operation panel (inside indoor unit) and Indoor Unit (K type) is of its front panel.
RCS-SH80BG.WL/RCS-TRP80BG.WL/RCS-XM18BG.WL/ Indoor Unit (K type)
Start: press [Emergency Operation]
of the receiver.
If the indoor temperature is 24°C or greater when the unit starts running, it will act as a cooler.
If the indoor temperature is less than 24°C when the unit starts running, it will act as a heater.
Stop: press [Emergency Operation]
of the receiver again.
NOTE
• The Test Run/On and Test/On switches are for use when the unit is installed and test run. It is not for normal use.
• If the [Normal/Stop ALL] switch is on Stop ALL, the unit cannot receive signals from the remote control.
RCS-BH80BG.WL/RCS-SS80BG.WL
1. Press [Emergency Operation]
of the receiver
If the indoor temperature is 24°C or greater when the unit starts running, it will act as a cooler.
If the indoor temperature is less than 24°C when the unit starts running, it will act as a heater.
2. If you press
, the wind direction automatically oscillates up and down.
Stop: press [Emergency Operation]
of the receiver again.
NOTE
• The Test Run/On and Test/On switches are for use when the unit is installed and test run. It is not for normal use.
• If the [Normal/Stop ALL] switch is on Stop ALL, the unit cannot receive signals from the remote control.
Indoor Unit (K type)
RCS-TRP80BG.WLRCS-SH80BG.WL
RCS-XM18BG.WL
Start/Stop
Start/Stop
Start/Stop
Start/Stop
21
RCS-SS80BG.WL RCS-BH80BG.WL
1
2
8-9
SM830160-03ClassicPAC-iA4.ind99SM830160-03ClassicPAC-iA4.ind99 2010/02/1610:31:172010/02/1610:31:17
To Next Page
Loading...
Need help?
General
