221
Installing the Fixing Angle Bracket
To prevent the register from moving when the drawer opens, the fi xing angle bracket is supplied with the
register. By attaching the bracket to the table where the register is installed, you can hock the register on
this bracket and secure the register to its position.
How to install the fi xing angle bracket
1.
Thoroughly clean the location where the fi xing angle
bracket (B) is to be placed.
2.
Peel off the adhesive tape on the fi xing angle bracket.
3.
Hook the angle bracket onto the hook (A) that is located
at the bottom rear of the register.
4.
Firmly stick the fi xing angle bracket to the table surface
that your cleaned above.
How to remove the register from the fi xing angle bracket
1.
Lift up the front of the register and pull the register
towards you.
To Next Page
Loading...
Need help?
General
