Configuration, displays and display elements
7.2 Show Location
SCALANCE X-300
144 Operating Instructions, 02/2012, A5E01113043-12
7.2 Show Location
Localizing an IE Switches X-300
To identify an IE Switch X-300 locally and with certainty, you can use the "show location"
function on a programming device to select the node over the network and make it flash.
This can be used, for example, when assigning addresses to make sure that the correct
node receives the address. All port LEDs of the addressed node flash green at 2 Hz.
With the PST Tool V3.0 or higher, you can trigger this function with "Module \ Flash".
7.3 XR-300 diagnostics port
RJ-11 jack on the rear of the device
The diagnostics port of a SCALANCE XR-300M is located on the rear of the device and is an
RJ-11 jack. Connect this port to the serial interface (RS-232) of a PC. A connecting cable
with suitable connectors ships with the XR-300M.
Figure 7-2 Diagnostics port
To Next Page
Loading...
Need help?
General
