Equipment
Manual OP7, OP17
This manual contains notices which you should observe to ensure your own personal safety, as
well as to protect the product and connected equipment. These notices are highlighted in the
manual by a warning triangle and are marked as follows according to the level of danger:
!
Warning
indicates that death, severe personal injury or substantial property damage can result if proper
precautions are not taken.
!
Caution
indicates
that minor personal injury or property damage can result if proper precautions are not
taken.
Note
draws
your attention to particularly important information on the product, handling the product, or
to a particular part of the documentation.
Equipment
may be commissioned and operated only by
qualified
personnel
. Qualified personnel
within the meaning of the safety notices in this manual are persons who are authorized to commis
-
sion, ground and identify equipment, systems and circuits in accordance with safety engineering
standards.
Note the following:
!
Warning
The equipment may be used only for the applications stipulated in the catalog and in the techni-
cal description and only in conjunction with other equipment and components recommended or
approved by Siemens.
Startup
must not take place until it is established that the machine, which is to accommodate this
component, is in conformity with the guideline 89/392/EEC.
Faultless and safe operation of the product presupposes proper transportation, proper storage,
erection and installation as well as careful operation and maintenance.
SIMATIC
is a registered trademark of Siemens AG.
Some of the other designations used in these documents are also registered trademarks; the
owner’s rights may be violated if they are used be third parties for their own purposes.
Editor and Publisher: A&D PT1
We
have checked the contents of this manual for agreement with
the
hardware
and software described. Since deviations cannot be pre
-
cluded
entirely
, we cannot guarantee full agreement. However
, the
data
in this manual
are reviewed regularly and any necessary cor
-
rections
included in subsequent editions. Suggestions for improve
-
ment
are welcomed.
T
echnical data subject to change.
Siemens
AG 1996
Disclaimer of Liability
Copyright
Siemens
AG 1996 All rights reserved
The reproduction, transmission or use of this document or its
contents is not permitted without express written authority.
Offenders will be liable for damages. All rights, including rights
created
by patent grant
or registration of a utility model or design, are
reserved.
Siemens
AG,
Automation & Drives
SIMA
TIC Human Machine Interface
Postfach 4848,
D-90327 Nuernberg
Siemens Aktiengesellschaft
Order No. 6A
V3991–1AE05–1AB0
Safety
Guidelines
Qualified Personnel
Correct Usage
Trademarks
Impressum
To Next Page
Loading...
Need help?
General
