Commissioning (software)
6.8 Activating the infeed (line module)
SIMOTION D4x5-2
242 Commissioning and Hardware Installation Manual, 02/2012
6.8.3 Using one infeed for several CUs
If the infeed is controlled from another control unit, then the Ready for operation signal of the
infeed (parameter r0863.0) must be connected to parameter p0864 "Infeed operation" of the
drive via a digital input/output. If this is not taken into account, the infeed may be damaged.
An interconnection of the Ready for operation signal via PROFIBUS/PROFINET is not
recommended because of the delay times (communication, evaluation in controller, etc.).
For a CX32-2, the Ready for operation signal of an infeed on the SINAMICS Integrated can
be simply interconnected to the drives of a CX32-2.
Further information on how to use line modules with the CX32-2 can be found in Section
Interconnecting the infeed "Operation" si
gnal on the CX32-2 (Page 204).
To Next Page
Loading...
Need help?
General
