EasyManuals Logo
Home>Siemens>Media Converter>SINAMICS DCM

Siemens SINAMICS DCM User Manual

Siemens SINAMICS DCM
758 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #222 background imageLoading...
Page #222 background image
Additional system components
7.3 Sensor Module Cabinet-Mounted SMC30
SINAMICS DCM DC Converter
220 Operating Instructions, 12/2018, A5E34763375A
7.3.9
Technical data
Table 7- 18 Technical data
6SL3055-0AA00-5CA2
Unit
Value
Electronic power supply
Voltage
Current (without encoder system)
Current (with encoder system)
Power loss
V
DC
A
DC
A
DC
W
24 DC (20.4 – 28.8)
≤ 0.20
≤ 0.55
≤ 10
Encoder system power supply
Voltage
Current
V
encoder
A
encoder
5 V DC (with or without Remote Sense)
1)
or V
DC
- 1 V
0.35
Encoder frequency that can be evaluated
(f
encoder
)
kHz ≤ 300
SSI baud rate
kHz
100 - 1000
2)
PE/ground connection
On enclosure with M4/1.8 Nm screw
Ventilation clearances, above/below
mm
50
Weight
0.45
1)
A controller compares the encoder system supply voltage – sensed via the Remote Sense cables – with the reference
supply voltage of the encoder system, and adjusts the supply voltage for the encoder system at the output of the drive
module until the required supply voltage is obtained directly at the encoder system (only for 5 V encoder system power
supply). Remote Sense only to X520.
2)
See the diagram "Maximum cable lengths depending on the SSI baud rate for SSI encoders"
Connectable encoder systems
Table 7- 19 Specification of encoder systems that can be connected
Parameter
Designation
Threshold
Min.
Max.
Unit
High signal level
(TTL bipolar at X520 or X521/X531)
1)
U
Hdiff
2 5 V
Low signal level
(TTL bipolar at X520 or X521/X531)
1)
U
Ldiff
-5 -2 V
High signal level
(HTL unipolar)
U
H
High 17 V
CC
V
Low
10
V
CC
V
Low signal level
(HTL unipolar)
U
L
High
0
7
V
Low
0
2
V
High signal level
(HTL bipolar)
2)
U
Hdiff
3 V
CC
V
Low signal level
(HTL bipolar)
2)
U
Ldiff
-V
CC
-3 V
High signal level
(SSI bipolar at X520 or X521/X531)
1)
U
Hdiff
2 5 V
Low signal level
(SSI bipolar at X520 or X521/X531)
1)
U
Ldiff
-5 -2 V
Signal frequency
f
S
-
300
kHz
Edge clearance
t
min
100
-
ns

Table of Contents

Other manuals for Siemens SINAMICS DCM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINAMICS DCM and is the answer not in the manual?

Siemens SINAMICS DCM Specifications

General IconGeneral
BrandSiemens
ModelSINAMICS DCM
CategoryMedia Converter
LanguageEnglish

Related product manuals