Siemens SINUMERIK 810D Programming Manual

Motion synchronous actions
10.4 Actions in synchronized actions
Job planning
Programming Manual, 03/2006 Edition, 6FC5398-2BP10-1BA0
10-65
10.4.30 Time use evaluation of synchronized actions
Function
In a interpolation cycle, synchronized actions have to be both interpreted and motions
calculated by the NC. The system variables presented below provide synchronized actions
with information about the current time shares that synchronized actions have of the
interpolation cycle and about the computation time of the position controllers.
$&B6<1&B$&7B/2$'
$&B6<1&B$&7B/2$'
$1B6<1&B$&7B/2$'
$1B,32B$&7B/2$'
W
01B,32B0$;B/2$'
&RPSWLPHIRUV\QFKDFWLRQVRQFKDQQHO
&RPSWLPHIRUV\QFKDFWLRQVRQFKDQQHO
IRUDOOFKDQQHOV
&XUUHQWFRPSWLPHIRU6$
&XUU,32FRPSXWLQJWLPHLQFOFKDQQHOV\QFK
/LPLWLQJYDOXHIRU,32F\FOHXWLOL]DWLRQ
,32F\FOH
FKDQQHOb
FKDQQHOb

Siemens SINUMERIK 810D Specifications

General

Brand	Siemens
Model	SINUMERIK 810D
Category	Control Unit
Language	English