Appendix
A.5 Default Settings
SIPROTEC, 7SJ62/64, Manual
C53000-G1140-C207-2, Release date 01.2008
617
Table A-8 Further Output Relay Presettings for 7SJ64
Table A-9 Further Output Relay Presettings for 7SJ641/2/5/7
A.5.4 Function Keys
Table A-10 Applies to All Devices and Ordered Variants
A.5.5 Default Display
In devices with 4-line displays and depending on the device version, a number of predefined measured value
pages are available. The start page of the default display appearing after startup of the device can be selected
in the device data via parameter 640 Start image DD.
In devices with graphic display, there is a default display indicating the actual operating state and/or selected
measured values. The display size is selected during configuration.
Binary Output Default function Function No. Description
BO3 Relay TRIP 511 Relay GENERAL TRIP command
52Breaker 52 Breaker
BO4 52Breaker 52 Breaker
79 Close 2851 79 - Close command
BO5 52Breaker 52 Breaker
79 Close 2851 79 - Close command
Binary Output Default function Function No. Description
BO1 GndSwit. Ground Switch
BO2 GndSwit. Ground Switch
BO10 Disc.Swit. Disconnect Switch
BO11 Disc.Swit. Disconnect Switch
Function Keys Default function
F1 Display of operational indications
F2 Display of the primary operational measured values
F3 Display of the last fault event recording
F4 Not allocated
www . ElectricalPartManuals . com
To Next Page
Loading...
Need help?
General