Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
7 Replace the lambda probe
⇒ t7.1 he LSF lambda probe (4-pole)”, page 111
⇒ t7.2 he LSU lambda probe (6-pole)”, page 112
⇒ p7.3 ipe variants of the unit lambda probes”, page 113
7.1 Replace the LSF lambda probe (4-
pole)
Note
♦
Where necessary, repair the attachment parts enclosed with
the unit probe, cable ties or marking tapes after presenting
the faulty probe.
♦
The cables on the lambda probe must not be repaired as
this can lead to malfunction.
– Remove the defective lambda sensor from the ⇒ engine;
Rep. gr. 24, petrol engine or ⇒ engine; Rep. gr. 23, diesel
engine.
– Place the two lambda probes next to each other so that the
sensor housing is at one height, see fig.
– Fix the excess length of the unit probe (approx. 50 - 250
mm) by tying it back to the length of the cable ties -1-.
– Check whether the timing case of the lambda probe is com‐
patible with the on-board network side.
– Where necessary, replace the on-board connector with the
supplied connector housing of the Lambda probe.
Citigo 2012 ➤, Citigo-e iV 2020 ➤, Enyaq 2021 ➤, Enyaq Coupe 2021 ➤, Fabia 2000 ...
Electrical System - general notes - Edition 12.2021
7. Replace the lambda probe 111
To Next Page
Loading...
Need help?
General
